Introduction to Basics Of CNC System – Architecture, Motors, Drives, Encoders And Troubleshooting

Date : 21 January, 2021

Time : 1000 Hrs to 1300 Hrs ( Online Mode )

INTRODUCTION

The program Control system for CNC Machine Tool is essentially designed and structured to meet the needs of all practicing engineers, particularly from Electrical and Electronics background, engaged in the areas of Design, Assembly & Interfacing, and Testing and Service of CNC machine tools. Program provides insight into the working of a closed loop system with all major constituents of the CNC control Viz: NC, PLC, Drives and Feedback elements covered and explained in detail.

FOCUS AREAS		KEY TAKE AWAYS
Introduction to machine tools Evolution of machine tools Fundamentals of CNC systems and CNC architecture Power elements as switching devices AC spindle and feed drives Four quadrant operation Spindle motor characteristics Block diagram of closed loop system Regenerative braking Section of 6 pole synchronous servo motor Variable frequency drives Monitoring circuits used in drives Real time requirements for a digital drive interface Grounding of all machines		Refresh CNC fundamentals Selection of CNC system and motor optimization Understand easy Interfacing of CNC Select hardware based on space, location and reliability Make a selection on less hardware with greater reliability Diagnose a fault faster Fine tune a CNC parameter for improved performance

Fee Per Participant (Per Login)

Rs. 2000/-
+18% GST

IMTMA Members/ Micro Companies/ Individuals/ Educational Institutions / Students/ IMTMA Non Members/ Others

USD 60/-

Overseas Participants

Faculty

This programme will be conducted by Mr. TK Venkatesh.
Mr. TK Venkatesh comes with 4 decades of rich experience in the CNC Machine Tools domain. After his graduation in Electronics & Communication Engineering, he had served HMT for 24 years in Design & Development of CNC Machine Tools of different types as well as Automation systems. He was General Manager – Servicing at AMS for 15 plus years supporting all the customers in India as well as overseas. He had played a lead role in Reliability Improvement program of CNC Machine Tools at AMS and IMTMA - ACMA Task force for bench marking of electrical systems of CNC Machine Tools.

For Registration Contact

Mr Shashank Kumar Singh
Programme Coordinator
+91 7571081726
gurgaontraining-sks@imtma.in

Nishant Singh
9823174010
nishant@imtma.in

Contact Address

INDIAN MACHINE TOOL MANUFACTURERS' ASSOCIATION
Plot 249F, Phase IV, Udyog vihar,Sector - 18,
Gurgaon - 122015

Tata no- +91-124-6463101
Tel : 0124 4014101 - 04
Fax : +91-124-4014108

REGISTRATION : Prior registration with an online advance payment is must. Number of participants is limited and will be accepted on ‘First Come First Serve’ basis. A Certificate of participation will be issued to participants.